Wacker Neuson BTS 635s Betreibershandbuch PDF herunterladen (Seite 67)

BTS 630, 635 11 Troubleshooting

Operator's manual 67

11 Troubleshooting

Potential faults, their causes and remedies can be found in the following table.

Notify your Wacker Neuson representative in case of malfunctions you cannot or

may not remedy yourself.

Malfunction Cause Remedy

Engine does not start. Multifunction switch is in the

stop position.

Set multifunction switch to the

"I" or the "Choke" position.

Spark plug cap is defective. Have the machine repaired. *

* Have these tasks carried out by the service department of your Wacker Neuson representative.

Spark plug is defective. Replace spark plug.

Spark plug is loose. Tighten spark plug.

Spark plug gap is set

incorrectly.

Set spark plug gap.

Fuel filter is clogged. Replace fuel filter.

Engine shuts off right after

starting.

Idle speed is adjusted

incorrectly.

Set idle speed.

Fuel filter is clogged. Replace fuel filter.

Fuel tank is empty. Top up with fuel.

Engine has low performance. Air cleaner is dirty. Replace air cleaner.

Cutting blade does not rotate. V-belt is defective. Replace V-belt.

Clutch is defective. Have the machine repaired. *

Cutting blade rotates in idle. Idle speed is adjusted

incorrectly.

Set idle speed.

Engine cannot be turned off. Electrical connection of the

multifunction switch is

defective.

1. Set multifunction switch to

"Choke". The engine will

switch off after a few

seconds.

2. Have the machine repaired. *

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 79 80

Keine Kommentare

Wacker Neuson BTS 635s Betreibershandbuch Seite 67