Wacker Neuson GP 3800A Betreibershandbuch PDF herunterladen (Seite 32)

Operation GP 3800A

5.16 To Start

See Graphic: wc_gr002499

Before starting, be sure you read and understand all the safety and

operating instructions in this manual.

5.16.1 Disconnect all loads from the generator and place the main breaker in

the "OFF" position (a2).

5.16.2 Set the Auto Idle Switch (c) to "OFF".

5.16.3 Open the fuel valve (d1).

Note: If the engine is cold, move the choke lever to the closed position

(e2). If the engine is hot, set the choke to the open position (e1).

5.16.4 Turn the engine switch to "ON" (b1).

5.16.5 Pull the starter rope (f).

Note: If the oil level in the engine is low, the engine will not start. If this

happens, check the oil level and add oil as needed.

5.16.6 As the engine warms up, move the choke lever to the OPEN position

(e1).

5.16.7 Allow the engine to warm up for a few minutes before placing the main

breaker in the "ON" position (a1) and attaching loads.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 49 50

Keine Kommentare

Wacker Neuson GP 3800A Betreibershandbuch Seite 32