Wacker Neuson EHB 10 series Betreibershandbuch PDF herunterladen (Seite 37)

EHB 11 Operation

7.3.4 Tool holder for tool with spline shaft

Inserting tool

1. Clean tool end.

2. Turn lock bolt by 90°.

3. Push tool into the tool holder as far as it will go.

When inserting a chisel, make sure the notch on the tool points towards the

spline shaft.

4. Turn lock bolt back by 90°.

5. Check to see if the tool is locked by pulling on the tool.

Removing tool

1. Turn lock bolt by 90°.

2. Remove tool from the tool holder.

3. Return lock bolt to original position.

Item Designation

1 Tool

2 Lock bolt

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Keine Kommentare

Wacker Neuson EHB 10 series Betreibershandbuch Seite 37