Wacker Neuson CRT 48-31V Betreibershandbuch PDF herunterladen (Seite 27)

CRT 48 Operation

wc_tx000641gb.fm 27

4.6 Vanguard—Starting

Before starting the operator must know the location and function of all

controls.

4.6.1 Turn and hold engine keyswitch until the engine starts.

Note: If the engine is cold, pull out the choke control knob fully.

NOTICE: Cranking the engine for more than 5 seconds can cause

starter damage. If the engine fails to start, release the keyswitch and

wait 10 seconds before operating the starter again.

4.6.2 Allow the engine to warm up before operating the trowel.

4.7 Lombardini—Starting

Before starting the operator must know the location and function of all

controls.

4.7.1 Turn the engine keyswitch to the run position.

4.7.2 When the glow plug indicator light turns off, turn keyswitch to start

position and hold until the engine starts.

NOTICE: Cranking the engine for more than 5 seconds can cause

starter damage. If the engine fails to start, release the keyswitch and

wait 10 seconds before operating the starter again.

4.7.3 Allow the engine to warm up before operating the trowel.

4.8 Stopping

To stop trowel movement, return control levers to their neutral position

and release pressure on the throttle foot pedal.

To stop the engine, turn the keyswitch to “O” (off).

4.9 Operation

To utilize your Wacker Neuson Ride-On Trowel to its fullest capacity,

the machine should be driven in the direction that the operator is

facing. This will finish the widest possible area, while giving the

operator an excellent view of the slab surface about to be troweled.

When the machine reaches the end of the slab, make a 180° U-turn,

and repeat the straight line of direction to the other end of the slab.

Note: During the break-in period, run the engine at 50% of full throttle.

Refer to Section New Machines.

NOTICE: DO NOT use excessive pressure on the control levers.

Excessive pressure does not increase the reaction time of the machine

and can damage the steering controls.

NOTICE: Attempting to use the trowel too early in the curing stage of

the concrete may result in an undesirable finish. Only experienced

concrete finishers should operate the trowel.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 75 76

Keine Kommentare

Wacker Neuson CRT 48-31V Betreibershandbuch Seite 27