Wacker Neuson Cub 200 Betreibershandbuch PDF herunterladen (Seite 31)

HI 110 / 200 / 300 Operation

ghi_tx001447gb.fm 31

4.12 Starting the Machine

Requirements

 Machine properly positioned

 Power connected

 Pre-Starting Checks completed

Procedure

To start the machine, follow the procedure below.

1. Select an operation mode.

a.Continuous heat mode (I)

b.thermostat mode (II)

Operational

sequence

The following sequence of events will occur.

1. The blower will start.

Nozzle heater

Note: The burner may not fire immediately on startup if the nozzle is cold. HI 200

HD and HI 300 HD machines are equipped with an additional heater that warms

the nozzle to the required operating temperature. After you select the ON (heat)

mode, the nozzle preheating sequence may cause a delay of up to 6 minutes

before the burner fires.

2. The burner will start firing.

 If a remote thermostat is not being used, the burner will fire continuously.

 In applications in which the remote thermostat is being used, the burner will fire

until the air temperature of the application area reaches the target temperature

set by the remote thermostat. At that time, the burner will shut off, but the blower

will continue to operate. When the air temperature of the application area falls

below the target temperature set by the remote thermostat, the burner will refire.

The process continues as long as there is fuel for the burner.

wc_gr007558

RESET

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

Keine Kommentare

Wacker Neuson Cub 200 Betreibershandbuch Seite 31