Wacker Neuson BH 23 Betreibershandbuch PDF herunterladen (Seite 16)

Safety instructions

SV00044GB 14

2.2.16 Stop engine before filling fuel tank. When refilling fuel tank, do not

allow fuel to come into contact with the hot parts of the engine or spill

onto the ground.

2.2.17 Make sure that sufficient fresh air is available when operating drilling

and breaking hammers with combustion engines in enclosed areas,

tunnels, adits, and deep trenches. For this particular use we offer

drilling and breaking hammers with electrive drive.

2.2.18 Do not operate this machine in areas where explosions may occur.

2.3 Safety checks

2.3.1 Drilling and breaking hammers may only be operated with all safety

devices installed.

2.3.2 Before starting operation, the operator has to check that all control and

safety devices function properly.

2.3.3 Before starting operation, the overload clutch of drilling hammers has

to be checked for proper functioning.

2.3.4 In case of defects of the safety devices or other defects reducing the

operational safety of the drilling and breaking hammers, the supervisor

has to be informed immediately.

2.3.5 The machine must to be switched off immediately in case of defects

jeopardizing the operational safety of the equipment.

2.4 Maintenance

2.4.1 Only use original spare parts. Modifications to this machine, including

the adjustment of the maximum engine speed set by the manufacturer,

are subject to the express approval of WACKER. In case of

nonobservance all liabilities shall be refused.

2.4.2 Stop engine and pull off spark plug cap (if available) before carrying

out maintenance jobs, to avoid unintentional starting of the machine.

Deviations from this are only allowed if the maintenance job requires a

running engine.

2.4.3 Take care when checking the ignition system.

The electronic ignition system produces a very high voltage.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Keine Kommentare

Wacker Neuson BH 23 Betreibershandbuch Seite 16